Publicité
PRODUCT SPECIFICATIONS
Voltage / Frequency / Phase
Maximum seating capacity:
Water capacity:
Inner/outer size:
Height:
Bubble air blower:
Filter pump fl ow rate:
Heater power:
Temperature range:
Temperature rise:
Number of Bubble Jets:
Spa tub recommended working air pressure:
RF frequency band: 2408~2476MHz
Wifi frequency band: 2412~2484MHz
Radio frequency radiation exposure Information:
This equipment complies with the radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance of 20 cm (7.9'') between the radiator and your
body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Infl atable, portable aboveground cord-connected spa with pump, heater, blower, built-in hard water treatment,
sanitation system and control panel.
Note: the spa equipment features a complete grounding system that is also in contact with the spa water. It is
possible that a person may build up static electricity that discharges when touching the water. Regardless, any
electric shock experienced should be investigated by a qualifi ed electrician prior to use of the spa. Unplug the spa
until the cause is determined and any corrective action completed.
Hereby, Intex Development Company Limited, declares that this SB-HSWF20 is in compliance with the essential
requirements and other relevant provisions of Derective 2014/53/EU.
Risk of fi re: This product draws a minimum of 13 AMPS. Most household circuits are 13 to 16 AMPS. If the circuit
breaker trips, please check that no other appliances or other large loads are on the same circuit as the spa.
Never use an extension cord. Unfold the line cord prior to use. Never place the plug on combustible materials.
Site preparation and requirements
• The spa can be installed indoor or outdoor. For household use only.
• Make sure the area is water resistant, level, fl at and free of sharp objects under or around the spa.
• Provide a properly located grounded electrical outlet with a protection grade of IPX4 or higher to connect the spa
and allow easy access for periodic testing of the cord mounted RCD.
• Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance and/or
service.
• The area shall facilitate draining purposes during long term spa storage. Check local and national regulations
regarding spa water disposal requirements.
• To reduce noise disturbance, do not install the spa in the immediate vicinity of vertical walls.
• The area shall be within reach of fresh water supply in compliance with local water regulations, and whose
parameters shall be adjusted according to the spa water chemistry and balance section of the manual before fi rst
use of the spa.
• Check your local laws and regulations regarding indoor and/or outdoor spa installation.
NOTE: Before setting up and fi lling the spa with water, make sure the area where the spa will be installed is
within your WiFi router coverage range. The area shall be free from metallic walls/mesh and other objects that
may interfere with or reduce the WiFi signal.
S AVE THESE INSTRUCTIONS
(353IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 11/19/2021
220 - 240 V / 50 Hz / 1 PH
4 adults
210 gal (795 L)
63/83 in (160/211 cm)
460 gal/hr (1,741 L/hr)
10ºC – 40ºC (50ºF – 104ºF)
1.5-2.5ºC/hr (3ºF – 4.5ºF/hr)
140
0.083 bar (1.2 psi)
Transmitter power: 10dBm
Maximum transmitter power: 100mW
WARNING
SET UP
English
6 adults
290 gal (1098 L)
74/94 in (188/239 cm)
28 in (71 cm)
800 Watts
2,200 Watts
1-2ºC/hr (2ºF – 3.5ºF/hr)
170
Page 9
353
A
Publicité
