Publicité
MAINTENANCE (continued)
Spa Cover
Inspect the spa cover regularly for leaks, premature wear and tear, damage, or signs of deterioration. Never use
a worn or damaged cover: it will not provide the level of protection required to prevent unsupervised access to
the spa by a child.
Clean the cover inside and outside periodically using a sponge and a suitable solution that includes adequate
disinfection (10 mg per liter of free chlorine). Do not use steel wool, hard brushes or abrasive cleaners.
Spa Surround
Barefoot areas and relaxing areas around the spa shall be cleaned on a regular basis. No cleaning water may
fl ow into the spa or spa water cycle. The dirt and cleaning agents shall be rinsed carefully to drain in the spa
surround.
Spa Tub and Cover Air Bladder Repair
Use the enclosed repair patch to repair any puncture:
•
Clean and dry the area to be repaired thoroughly.
•
Remove the patch backing paper and press patch fi rmly over the puncture. Smooth out the surface to
remove any air bubbles under the patch.
In regions subject to freezing temperatures, drain, clean, disassemble and properly store the spa set and related
components indoors when the temperature drops below 4°C (39°F).
1.
Drain and clean the spa following the "Spa Tub Drainage" and "Spa Tub Cleaning" sections.
2.
Reverse set up instructions to defl ate and disassemble the spa tub, spa control unit and spa cover air
bladder.
3.
To defl ate the tub:
a)
With the spa control unit attached to the spa tub, turn the air passage selection dial on the side of the
control base to "
b)
Press the air bubble
c)
When defl ation is completed, turn the air passage selection dial back to "
press the
button again to turn it off .
To defl ate the cover air bladder:
a)
Disconnect the spa control unit from the spa tub wall.
b)
Attach the infl ation hose (7) to the spa control base air blower outlet (see drawing 3).
c)
Open the cover air bladder valve and insert the other end of the infl ation hose (7) into the valve (see
drawing 4).
d)
Turn the air passage selection dial to "
e)
Press the air bubble
f)
When defl ation is completed, turn the air passage selection dial back to"
press the
button again to turn it off .
Caution: Only use for the purpose described in this manual. Keep the infl ation hose away from water or
small objects when the defl ation function is activated to avoid damage to the blower motor.
4.
Make sure all the spa components and accessories are thoroughly clean and dry before storage. Air-dry the
spa tub in the sun for an hour before folding.
5.
Fold the spa tub loosely and avoid any sharp corners to prevent damage or leakage to the spa tub liner.
6.
Prepare additional new cartridges for next time use.
7.
Store the spa tub and accessories indoors, in a dry, temperature controlled, between 0º – 40ºC
(32º – 104ºF), storage location.
8.
The original packing can be used for storage.
S AVE THESE INSTRUCTIONS
STORAGE
" defl ate position (see drawing 11).
button to defl ate the tub (see drawing 12).
" defl ate position (see drawing 11).
button to defl ate the cover air bladder.
(353IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 11/19/2021
" bubble position and
" bubble position and
353
English
A
Page 29
Publicité
