Télécharger Imprimer la page

Intex 128452EX Manuel Du Propriétaire page 14

Masquer les pouces Voir aussi pour 128452EX:

Publicité

Release Air
For Spa Tub Wall:
1.
With the spa control unit attached to the spa tub, turn the air
passage selection dial on the side of the control base to "
defl ate position (see drawing 11).
2.
Press the air bubble
3.
When defl ation is completed, turn the air passage selection dial
back to "
" bubble position and press the
turn it off .
To defl ate the spa tub for storage, see "STORAGE" section.
For Cover Air Bladder:
1.
Pull the valve cap out and squeeze the valve at its base to release
a small amount of air.
2.
Close and recess the valve back.
To defl ate the cover air bladder for storage, see "STORAGE" section.
Accesories assembly and water fi lling
1.
Attach the fi lter cartridge housing assembly to the inside of the spa
tub outlet grid (lower position) (see drawing 13).
NOTE: Infl ate the spa tub fi rst before installing fi lter pump fi ttings.
2.
Before fi lling with water ensure the bottom drain valve caps are
securely closed on the inside and outside.
3.
Fill the spa tub with freshwater to a level between MIN and MAX
marked on the inside of the spa wall. Do not over fi ll the spa.
Never move the spa tub with water inside and/or with the control
base attached to the spa as the spa or control base may be
damaged.
WARNING: Never pour water with a temperature
higher than 40°C (104°F) into the spa directly. It is
recommended to fi ll the spa tub with lukewarm water
for quick heating and energy saving.
4.
Place the spa cover and spa air bladder (pre-installed in spa cover) over the spa tub, and make sure the
spa cover buckles are locked using the key provided after pulling the buckled straps tight.
IMPORTANT: Inspect the spa cover regularly for leak, premature wear and tear or deterioration. Never
use a damaged spa cover.
5.
Ensure that the spa base is plugged into a properly located and sized electrical outlet and press the
button to turn on the control panel. Press the
"Spa Control Panel" operation section.
S AVE THESE INSTRUCTIONS
SET UP (continued)
button to defl ate the tub (see drawing 12).
button again to
button on the control panel to activate the heater, see
(353IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 11/19/2021
"
353
English
A
11
12
13
Page 13

Publicité

loading

Ce manuel est également adapté pour:

Purespa greystone deluxe sb-hswf20