OZ Lifting Products OZSS025GBT Manuel D'utilisation page 6

On the STAINLESS SERIES GEARED BEAM TROLLEY, there may be an anti-
tilt pin located on the sideplate opposite the handwheel. This pin should be
adjusted so that the wheel (pin side) on the sideplate cannot lift off the beam.
Some clearance should be allowed so that the trolley moves smoothly, typically
about a 1/8-inch gap.
OPERATION:
WARNINGS AND PRECAUTIONS
Trolley operators should read and fully comprehend this entire manual and all warnings on the trolleys
before beginning operation. If this manual is not read and followed completely, injuries may occur.
Operator Requirements:
• Be trained in proper trolley operation and in dealing with potential malfunctions.
• Abstain from use of alcohol, medications, or drugs while operating.
• Avoid operation while tired or distracted.
• Avoid operation if they have a history of seizures or other medical issues that may interfere
with operation.
• Have proper coordination and vision.
NOTE: Prior to operation, ensure trolley is in proper working condition and maintenance
records are up to date.
OPERATION
Be aware of trolley load capacity and don't overload.
Attach load to suspension plate directly under the trolley.
MAINTENANCE:
INSPECTION
Operators should visually inspect the trolleys on a regular basis. Observe for wear, damage, cuts, cracks,
or corrosion. If any problems are observed, the trolleys should be placed out of service until they can be
repaired. Use only OZ Lifting Products, LLC
Complete a monthly inspection of the suspension plate, track wheel, and locking nuts. Ensure that
locking nuts are secure.
Trolleys should be taken to an authorized repair center for professional inspection once a year.
6
for replacement parts.
®
EN