OZ Lifting Products OZSS025GBT Manuel D'utilisation page 5

DO NOT
lift more than the rated load.
DO NOT
lift people or lift loads over people.
DO NOT
operate with side or off center loading of load.
DO NOT
operate a damaged or malfunctioning product.
DO NOT
remove, deface, or cover warning labels.
DO NOT
leave a suspended load unattended, unless specific precautions are instituted.
DO NOT
operate until personnel are warned and cleared from the area.
DO NOT
operate if locking nuts are not tight and locked in position.
DO NOT
operate if space washers are not correctly spaced.
DO NOT
operate if end stops are defective and don't restrain the trolley.
DO NOT
use if load is not suspended vertically.
DO NOT
use trolleys as welding ground.
DO NOT
weld on the lifted load.
DO NOT
allow the load to swing.
DO NOT
use for any function other than that for which the product is designed.
PRE-INSTALLATION INSPECTION:
Check for damage during shipment. Do not install or use a damaged product. Be sure to maintain
records of product information and contact your OZ Lifting Products, LLC
that arise. Refer to applicable codes and regulations before installing equipment.
INSTALLATION:
Measure the width of the beam that the trolley will be mounted on. Ensure that the beam is within
the adjustable flange width range of the trolley.
Using the provided washers/spacers, assemble an equal number of washers/spacers on each side
of the bail to position the sideplates so that there is an 1/8" gap between the flange of each wheel
and the beam. The bail must be centered. The extra washers should be placed equally on the
outside of the sideplates.
NOTE: There must always be at least one washer on both sides of each sideplate.
Once the correct number of washers/spacers are in place, loosen the nuts slightly. This will allow the
sideplates to be installed over the beam more easily.
With the sideplates installed onto the beam, firmly tighten the nuts on both sides of the trolley.
Secure these nuts with the second locknuts. Ensure that both sets of nuts are tight.
NOTE: Certain trolley models may utilize a castle nut secured with a split pin instead of double
nuts. If equipped, tighten each castle nut and secure with the corresponding split pin.
On OZSS025PBT, OZSS05PBT, and OZSS1PBT, there may be an anti-tilt pin
located on each sideplate. These pins should be adjusted so that the wheel on
the sideplate cannot lift off the beam. Some clearance should be allowed so
that the trolley moves smoothly, typically about a 1/8-inch gap.
EN
Failure to read and comply with the following warnings may result in a
hazardous situation that could lead to death, serious injury, or property
damage.
Read and comply with all instructions and warnings furnished with or
attached to the product, if applicable.
dealer with any problems
®
5