Parkside PTPS 1100 A1 Traduction Des Instructions D'origine page 24

GB IE
Set the length of the
float switch cable
1. Hold the float switch height adjustment
(2) in position.
Float switch cable (12) set too short
2. Pull the float switch cable at the float
switch (3) to extend.
Float switch cable (12) set too long
3. Pull on the float switch cable at a point
before the float switch height adjust-
ment (2).
Manual mode
In manual mode, the pump does not switch
off automatically, as the float switch (
3) is bypassed.
Position the float switch (3) vertical-
ly upward in the float switch height
adjustment (2).
Monitor the pump constantly when
in manual mode. Switch the pump
off immediately (disconnect from the
mains) if no more water is being
pumped. There is a risk of damage
if the pump runs dry.
Operational start-up
• Check that the pump is standing
firmly on the bottom of the shaft
or hung up safely.
• Place the pump on a brick and
not on a shaft floor, if applica-
ble. This prevents damage to the
pump if the shaft floor is soiled.
• Check whether the pressure line
has been attached correctly and
the unused pump outlet is fully
24
closed.
• Avoid that the pump runs dry.
Regularly check the function
of the float switch. In case of
non-observance or if the pump
runs dry, guarantee and liability
claims are invalidated.
• Check that the electrical connec-
tion is 230 V~ 50 Hz
• Check the proper status of the
electrical plug socket and make
sure that the plug socket is suf-
ficiently fused (at least 6 A, RCD
switch). Insert the pump plug into
the plug socket and the pump is
ready for operation.
• Make sure that moisture or water
never come in contact with the
mains connection. There is a risk
of electrocution.
Cleaning/Maintenance/
Storage
Clean and maintain your equipment regu-
larly. This will guarantee its performance
and long durability.
Ask our service centre to carry out
any work that is not described in
these instructions. Use only original
parts.
This will prevent damage to the
equipment and any resulting per-
sonal injury.
Pull out the power plug before
every maintenance operation. There
is a risk of electrocution or of injury
from moving parts.
General cleaning instructions
• In case of transport for utilization in