Husqvarna 340 EPA II Manuel D'utilisation page 40

RECOMMENDED CUTTING EQUIPMENT FOR CANADA
The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws. The combinations of powerhead, bar
and chain meet all requirements outlined in the CSA Z62.1-95 Chainsaws and Z62.3-96 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be
considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less
kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which are available
at your dealer.
Bar and chain combinations
Length, inch Pitch, inch
13 0,325
15
16
18
13
15
16
18
20
Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the
corresponding bar, see the table below
0,050" H30
0,058" H25
Saw chain filing and file gauges
40 –
Canadian
TECHNICAL DATA
Bar
Gauge, inch Max. nose radius
1,3 10T
10T
10T
10T
1,5 10T
10T
10T
10T
12T
Chain
Type Drive link count
Husqvarna H30 56
64
66
72
Husqvarna H25 56
64
66
72
80