SilverCrest 412019 2110 Mode D'emploi page 12

Ironing with steam blast
■ The steam blast function is especially suitable for smoothing difficult-to-reach
parts of a garment.
NOTE
The temperature regulator 8 must be turned to at least the setting range
►
. Otherwise no steam will be produced.
To generate the maximum quantity of steam, the temperature regulator 8
must be set to the highest level (MAX
1) Raise the steam iron slightly.
2) For a steam blast, press the steam blast button
3) You can also use the steam blast function to smooth hanging textiles.
VERTICAL
Pausing operation of the steam iron
WARNING! RISK OF FIRE!
► Never leave a hot steam iron unattended if it is switched on or connected
to the mains power supply.
1) Move the temperature regulator 8 to the "MIN" position.
2) Stand the steam iron only on the base 0.
After use
■ Remove the plug from the mains power socket.
Empty the water tank and clean the sole of the iron q.
■
Place the cooled-down steam iron on the base 0.
■
Drip-stop function
With conventional steam irons, water can drip from the sole of the iron q at low
temperatures. This iron however, possesses a new feature, the DRIP-STOP function
(
blast function. When this happens, you will hear a "CLICK". Then set a suitable
temperature with the temperature regulator 8. As soon as this is reached, steam
production is resumed.
NOTE
► Wait until the set temperature has been reached before pressing the steam
blast button
iron.
SDB 2400 F4
Hold the iron vertically and press the steam blast button
). At low temperatures, the iron automatically switches off the steam-
4 again. Otherwise, water could drip from the sole of the
).
4.
GB │ IE
4.
│
9 ■