Install Door Panels - Jenn-Air JB36NXFXLW Guide D'installation

5. Attach a mounting bracket to the top edge of the door panel(s)
by placing the large ends of the keyhole slots over the screws
and sliding the bracket so that the screws are centered in the
slots.
NOTE: Start with the screws in the center of the slots as
shown, then move the door panel, as necessary, to align.
A
A. Door panel
6. Using the Phillips head flat screws (provided), fasten a
mounting bracket to each side of the drawer panel, as shown.
A
A. Drawer panel
B. Drawer panel mounting bracket
7. Using the slotted hex head screws provided, attach a
mounting bracket to each side of the grille panel.
NOTES:
See the Parts Provided insert sheet to select the brackets
designated for your installation.
Use the Integrated Grille brackets for an Integrated
Installation with a full height grille.
Use the Standard Grille brackets for a Standard
Installation with a flush grille, as shown.
8. Using round head screws (provided), attach the grille trim
piece to the bottom of the grill panel.
A. Top grille brackets
B. Grille trim piece
B
B. Mounting bracket
B
A
B
Remove Trim Pieces
1. Remove all tape and door bracing from the refrigerator and
freezer doors.
2. Open the refrigerator and freezer doors.
3. Remove the hinge cover pieces from the top and bottom of
the door to expose the holes in the hinges.
NOTES:
It is not necessary to remove the hinge side trims as they
will not interfere with the installation
Leave the freezer drawer trims in place for installation.
C
A. Hinge cover pieces
B. Handle-side door trim
C. Drawer trim

Install Door Panels

1. Lower the panel mounting bracket onto the adjustment pins at
the top of the door.
C
A. Door panel
B. Mounting bracket
2. Slide the studs, on the back side of the door panel, into the
"J" pockets in the front of the door.
A
B
A
A
B
C. Adjustment pins
19