Jenn-Air JB36NXFXLW Guide D'installation page 20

NOTE: French door models, repeat steps 1 and 2 to install the
second door panel.
3. Using a slotted hex head screw (provided), attach the
mounting bracket (factory installed), located at the bottom of
the refrigerator door(s), to the respective door panel(s). Do not
fully tighten the screw.
A
A. Bottom hinge
B. Mounting bracket
Install Drawer Panel
1. Align the slots in the mounting brackets, located on each side
of the drawer panel, with the holes that go through the drawer
trim and into the drawer.
2. Using Phillips head flat screws (provided), attach the brackets
to the drawer.
3. Move the drawer panel up and down or from side to side to
align. Do not fully tighten the screws.
A
B
A. Drawer overlay panel
B. Panel mounting bracket
20
Install Top Grille Panel
Standard Installation - Flush Grille
1. Hook the panel brackets onto the mounting bolts extending
2. Pull the grille panel down slightly to lock into place.
Integrated Installation - Full Height Grille
1. Align the bracket with the mounting bolts.
2. Push the grille panel forward until the bracket snaps into
Door Swing Adjustment
It may be necessary to adjust the swing of the door(s). Make sure
the refrigerator door(s) can open freely. If the door(s) opens too
wide, install the door stop pin (provided).
1. Hold the door open to a position that is less than 90°.
B
2. Insert the door stop pin into the top hinge in the hole shown.
3. Using a ⁵⁄₃₂" Allen wrench, tighten the door stop pin.
Complete Installation
1. Use the installation block to measure the gaps between the
from the top of the refrigerator.
place.
B
A. Top grille panel
B. Cabinet sides
A. Door stop pin hole
overlay panels and adjacent cabinets.
A B
A