Eureka NEN110 Serie Guide Du Propriétaire page 7

How to use your vacuum cleaner
CAUTION: Always switch off the vacuum cleaner before connecting or disconnecting the
hose/attachments or removing and emptying the dust cup.
IMPORTANT: The vacuum cleaner is equipped with a thermal cut-off. If for any reason the
vacuum cleaner does overheat, the thermostat will automatically turn the vacuum cleaner
off. If this happens, switch the vacuum cleaner off and unplug it from the electrical socket.
Remove and empty the dust cup and check the vacuum deaner for blockages. Allow the
vacuum cleaner to cool for approximately 1 hour (if you have cleaned the incorrect space,
please wait 24 hours for the lters to fully dry before putting them back into the machine).
Operation
Pull the power cord out of the vacuum cleaner and stop when you
see the yellow mark. Make sure the red mark is not visible or you
have pulled too far. When done cleaning, turn off the power, pull
the plug out of the electrical socket, and then push the rewind
button until the cord is completely retracted.
To turn on the vacuum cleaner, push the plug into an electrical
socket and press the power button.
Switching between carpet & hard oor
There is a switch located on the oor nozzle that can be pressed
with your foot to switch between oor modes. The symbols shown
below correspond to the type of oor the setting is for.
Position 1: Bristles extended for hard oor
Position 2: Bristles retracted for carpet
Position 1
Hard oor
Position 2
Carpet
7