Eureka NEN110 Serie Guide Du Propriétaire page 10

!
Make sure vacuum is turned off and power cord is unplugged.
This vacuum cleaner has a special thermostat that protects the vacuum in case of motor
overheating. If the vacuum suddenly shuts off, proceed as follows: 1) Push the power
switch to off and unplug the vacuum. 2) Check the vacuum for a possible source of
overheating such as a full dust cup, blocked hose or clogged lter. If these conditions
are found, x them and wait at least 30 minutes before attempting to use the vacuum. 3)
After the 30 minute period, plug the vacuum back in and turn on the switch.
Problem
The vacuum
cleaner does not
turn on
The vacuum
cleaner does not
work
The vacuum
cleaner suddenly
stops
Connecting to an electrical socket
Please check that the voltage indicated on the product corresponds with your supply voltage.
10
Problem solving
NOTICE: Thermal cut-off
Possible cause
• Too much dust in the cup
• Filter is blocked
• Hose is blocked
• Electrical outlet is not
connected or not working
• Power switch was not
turned on
• The dust cup is lled
• The lter is blocked
• Suction inlet of brush or
accessories is blocked
Solution
• Empty the dust cup
• Rinse the lter
• Clear the blockage
• Ensure the plug is properly
connected in the socket and
the socket is active
• Press the power button
• Empty the dust cup
• Clean the lter
• Clear the blockage