IARP EIS 112 HP Instructions Pour L'utilisateur page 17

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
9. EQUIPMENT IDENTIFICATION
• Located on the plate affixed to the machine to detect the technical data.
• Check the model and power supply voltage before carrying out any operation.
• If discrepancies are found, immediately contact the manufacturer or the company that supplied the equipment.
1. Manufacturer
2. Code
3. Conformity marking
4. Power supply voltage (V)
5. Power supply frequency (Hz)
6. Absorbed electrical power (W)
7. Absorbed electrical power in defrosting (W)
8. Light max. power (W)
9. Gross volume
10. Type and quantity of refrigerant
11. Climate class
It is strictly forbidden to remove, tamper with the plate and change or alter the data
contained in it.
10. DOOR OPENING
Warning!
MAXIMUM ANGLE OF DOOR OPENING = 110°
For correct working of the torsion bar and to avoid any break of the door or of the hinge do not
exceed the maximum angle of door opening i.e. 110°.
11. POSITIONING
COMPULSORY
INSTALLATION
Where present, adjust the front feet (using a pliers) to align the doors; the
equipment should be arranged on a flat surface.
EIS 112 HP
EIS 162 HP
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
The equipment is equipped with one-directional wheels and adjustable feet.
To stop and position the equipment, screw in or out the feet 10 mm lower than the
wheels.
It is strictly necessary after positioning to stabilise the equipment on
the ground.
ADJUSTMENT
1
4
5
6
7
8 9
ON EACH
✓
X
1 7 / 5 6
PAGE
UM000601
N° DOC
2
10
*Example of
11
data plates
11
3
MAX
110°
CORRECT
WRONG