SilverCrest 304535 Mode D'emploi page 60

NOTICE
► After the expiry of the preselected treatment time the UV lamps are switched
off automatically.
► The start button
for each new treatment.
Examine each nail, after the application and hardening of all coatings, for
unevenness, small scratches or ridges.
If you discover unevenness, apply a further thin layer of UV gel
en the nail with the setting of 150 seconds or 90 seconds (depending on the
amount of applied UV gel
Even after the last hardening of the Gel layer, the nails may feel a feel sticky
("sweat-layer" or polymerization layer).
Moisten a cellulose pad
the nail.
SNS 45 B4
and the time selector button
).
with finishing solution
must be activated again
and hard-
and then wipe this over
GB │ IE │
57 ■