Ryobi ETMS-1425 Manuel D'utilisation page 17

GB
F D
SAFETY INSTRUCTIONS
Never use the cable for any purpose other than that
■
for which it is intended!
Adopt a firm standing position and keep your balance
■
at all times.
Check the tool for signs of damage!
■
Before you carry on using the tool it is imperative to
■
check that its safety devices and any slightly damaged
parts are working properly and in the way intended.
Check that the moving parts work properly and do not
■
jam or whether any of the parts are damaged.
All parts must be fitted correctly and satisfy all
■
conditions for the tool to work properly.
Unless otherwise stated in these instructions, damaged
■
safety devices and parts must be repaired or replaced
by experts in an approved specialist workshop.
Have damaged switches replaced by an authorized
■
service centre.
This tool complies with the pertinent safety regulations.
■
Repairs are to be carried out only by qualified
electricians using original replacement parts. The user
may suffer an accident if this condition is not observed.
Be careful when working in vertical mode.
■
CAUTION
Special care is required when making compound
mitre cuts.
Do not overload your tool!
■
Wear safety goggles.
■
Wear a breathing mask on dusty jobs.
■
Examine the power cable / extension cable for
■
damage.
Never use damaged or worn blades.
■
Use only blades which are recommended by the
■
manufacturer and comply with EN 847-1.
Be careful when sawing in table saw mode.
■
Table saw mode: Make sure that the saw arm is
■
securely locked.
Cross-cut saw mode: Make sure that the upper guard
■
is fully closed.
Mitre saw mode: Make sure that the saw arm is
■
unlocked when cutting miters.
Wear goggles
Wear ear-muffs
Wear a breathing mask
E I P NL S DK N FIN
English
SPECIFICATION
Input
Power rating
Operating mode
No load speed
Saw blade dimension
Blade type
Connector for dust extractor
Standing area
AS TABLE SAW
Upper saw table
Cutting height
parallel stop swinging range
AS MITRE SAW
Bevel range
Mitre cuts
Lower saw table
Cutting depth
Mitre x Bevel:
0º x 0º
45º L x 0º
0º x 45º
45º L x 45º
DESCRIPTION
1. Release button
2. Handle
3. On/Off switch for mitre saw mode
4. On/Off switch for table saw mode
5. Saw blade
6. Lower guard, hinged
7. Back fence
8. Mitre table
9. Lower saw table stand
10. Mitre lock knob for turntable
11. Scale
12. Table insert, bottom
14. Catch
15. Changeover handle
16. Saw table
17. Upper saw blade guard
18. Parallel / Mitre stop
19. Hexagon wrench
20. Workpiece supports
21. Face wrench
22. Bevel lock knob
23. Retaining pin
25. Knurled screw for mitre settings
26. Knurled screw
27. Stop rail
11
GR H CZ RUS
230 V ~ 50 Hz
1400 W
S1
4000 min
ø 254 x ø 30 x 3,2 mm
40T TCT
ø 39.5 mm
500 x 500 mm
426 x 340 mm
40 mm
-45° to +45°
0° - 45° left
0° to 45° left
475 x 150 mm
70 x 127 mm
70 x 85 mm
38 x 127 mm
35 x 55 mm
RO PL
-1