Publicité
Les langues disponibles
Les langues disponibles
• The appliance must be used and left at rest on a stable surface.
• The appliance must not be used if it has been dropped, if there are visible signs
of damage or leaks of water. Do not use the appliance if the power cord or the
plug are damaged, or if the appliance is faulty. To prevent any accident, all re-
pairs, including the replacement of the power cord, must be carried out by an
Authorised Service Centre or, in any case, by qualified personnel.
• Never direct steam or hot water towards parts of the body; handle the steam/hot
water spout with care: Burns hazard!
• The external metallic parts of the appliance and the filter holder must not be touched
with the equipment in operation, as it could cause burns.
• If water does not come out of the filter holder, it may be because the filter is
clogged. Stop the brewing and wait ten seconds. Remove and disconnect the
filter holder because any remaining pressure could cause splashes or squirts.
Then clean as explained in the relevant paragraph.
• Place the machine on a steady surface where it can not be overturned.
• Never put any object other than the pods in the pod filter holder. This could cause
serious damage.
• Use only pods that show the E.S.E. standard brand.
• Do not use the machine without water because in this case the pump will burn.
• Never fill the water tank with hot or boiling water.
• Do not place the machine on very hot surfaces or near open flames to prevent
the body from being damaged.
• The cable must not touch the hot parts of the machine.
• Do not use sparkling (carbonated) water.
• Never put substances other than coffee powder in the filter. This could cause
serious damage.
• Do not leave the machine at temperatures below 0 °C / 32 °F, as the remaining
water in the boiler could freeze and cause damage.
• Do not use the appliance outdoors.
• Do not expose the appliance to atmospheric agents (rain, sun ...).
• After disconnecting the power plug and after the hot parts have cooled, the ap-
pliance must be cleaned only with a non-abrasive cloth slightly moistened by
adding a few drops of mild, non-aggressive detergent (never use solvents that
damage plastic).
• For proper disposal of the product in accordance with the European Direc-
tive 2012/19/EC please read the dedicated leaflet attached to the product.
• SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
16
Warning of burns
Warning – material damage
Publicité
