ARIETE 1389 Mode D'emploi page 18

coupling seat of the filter holder. Open the steam knob (M) and make water come out of the Maxi
Cappuccino device.
Stop dispensing setting the switch (Q) in the upper position. Close the steam knob. Wait for the light
(N) to turn on. At this point the coffee maker is ready to brew coffee.
HOW TO MAKE COFFEE
With powder coffee
Insert the dripper (B), the perforated silicone disc (C) and the 2 cup (E) or 1 cup (D) filter, in the
filter holder (A) (Fig. 6). The perforated silicone disc can be inserted only in one direction on the
dripper. Measure out the coffee in the filter and lightly press with the specially provided presser:
for two coffees completely fill two measuring units, while for one coffee fill only one. Insert the filter
holder into its seat. Tighten it securely by turning it from left to right, making sure it is correctly fitted
to the flange (Fig. 8).
If too much ground coffee is put inside the filter, turning the filter holder may prove difficult
and/or you may get leaks from the filter holder when the coffee is being dispensed.
The filter ring should be preheated for a few minutes to ensure a nice, hot cup of coffee. This will
not be necessary for the following coffees.
Wait for the light (N) to turn on. Position the switch (Q) to coffee brewing (
the spouts of the filter holder. Stop dispensing setting the switch (Q) in the upper position. The
minimum serving of coffee is 50 ml.
Warning!
As in professional coffee machines, do not remove the filter holder
when the dispensing switch is ON (in coffee position
Warning!
After dispensing coffee wait about ten seconds before removing the
filter holder. To remove it, turn it slowly from right to left so as to prevent
splashes or spurts of water or coffee.
When warming up, your appliance may release small puffs of steam from the filter holder;
this is perfectly normal.
The indicator light (N) will switch off and on periodically, showing the intervention of the boiler ther-
mostat, which serves to maintain the best water temperature (around 100 °C / 210 °F for making
coffee, and about 150 °C / 300 °F to dispense steam).
When using the coffee maker for the first time and thereafter, it is best to begin brewing coffee only
when the light (N) is on.
How to make coffee with pods
To make coffee with pods it is necessary to install the 1 cup/pod filter (D), supplied with the ma-
chine, as follows:
1 Place the pod in the filter ring (Fig. 17).
2 Push the pod with your fingers inward. The pod must be well centred and placed inside the filter.
3 Now it is possible to put the filter holder in its seat. Tighten the filter holder making sure it is
securely fitted to the flange (Fig. 8).
18
): coffee will flow from
).