Fein 7 223 02 Mode D'emploi page 13

OBJ_BUCH-0000000047-001.book Page 13 Monday, September 26, 2011 4:01 PM
en Original Instructions for Straight Grinder.
Symbols, abbreviations and terms used.
Symbol, character Explanation
Do not touch the rotating parts of the power tool.
Observe the instructions in the text or graphic opposite!
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Before commencing this work step, pull the mains plug out of the socket. Otherwise there will
be danger of injury if the power tool should start unintentionally.
Use eye protection during operation.
Use ear protection during operation.
Use protective gloves during operation.
A surface that can be touched may be very hot and thus hazardous.
Gripping surface
Additional information.
Confirms the conformity of the power tool with the directives of the European Community.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environmental-friendly recycling.
Product with double or reinforced insulation
Character Unit of measure,
international
n /min
P W
1
P W
2
U
V
f
Hz
M... mm
Ø mm
mm
mm
Fe
kg
L dB
pA
L dB
wA
L dB
pCpeak
K...
2
m/s
Unit of measure, Explanation
national
rpm Rated speed
W Power input
W Output
V Rated voltage
Hz Frequency
mm Size of metric thread
mm Diameter of a round part
mm Ø =Max. diameter of grinding wheel
D
T= Grinding wheel thickness
mm Drilling diameter, steel
kg Weight according to EPTA-Procedure 01/2003
dB Sound pressure level
dB Sound power level
dB Peak sound pressure level
Uncertainty
2
m/s Vibrational emission value according to EN 60745
(vector sum of three directions)
en
13