Publicité
Les langues disponibles
Les langues disponibles
GB
SLIDING CARRIAGE ADJUSTMENT
The sliding carriage is provided with a register for adjustment.
If any excessive vertical movement of the carriage should take place, act as follows:
1) with a 13 mm wrench and a 6 mm Allen wrench, loosen the lower wheel supports.
38
2) make the lower wheel support slide on the adjustment slot until the vertical play is eliminated.
39
3) lock the lower wheel support again.
IN CASE OF LATERAL MOVEMENTS OF THE CARRIAGE, TIGHTEN ALL THE WHEEL SUPPORTS STILL FURTHER.
DISPOSAL
In the event of scrapping the entire machine, it must be disposed of in accordance with the methods laid down by
current legislation.
Main Casing
Submerged Pump
Electric Motor
R.A.E.E. IT08020000002803
The European Directive 2012/19/EU arranges that in the event of scrapping of electrical equipment,
they must not be disposed of city solid refusals but collected separately, in order to optimize the level of
recovery and recycling of the materials and above all in order to prevent damages to health and
environment. To comply with European Directive 2012/19/EU, all electrical equipments must be marked with
crossed basket symbol. The packing of the machine will be disposed of in accordance with the methods laid
down by current legislation. For further information concerning disposal of electrical equipment, please refer to
public administration service.
TROUBLESHOOTING
HAVE YOUR TOOL REPAIRED BY A QUALIFIED PERSON
This electric tool complies with the relevant safety rules. Repairs should only be carried out by qualified
persons using original spare parts, otherwise this may result in considerable danger to the user.
Malfunctions not related to a conformity defect that exists at the time of purchase are excluded from the
warranty. Exclusions include:
•
Wear of materials (taking into account the average life of the product)
•
Failure to comply with the recommendations contained in this manual.
•
Maintenance and tampering carried out by unauthorized personnel.
•
Use of non-original spare parts.
EC DECLARATION OF CONFORMITY
BATTIPAV SRL (Z.I." Via Cavatorta 6/1-48033 Cotignola (RA) ITALY tel. 054540696 - info@battipav.com - www.
battipav.com) hereby declares under its sole responsibility that the product:
Series: EXPERT 400, 500, 600,700
Art: TAB 1
Model: Cutters for cutting on bricks, natural stones, granite, bricks, concrete products and the like up to a
height of 285mm.
This Declaration relates to the following Directives:
2006/42/EC (MD), 2014/35/EU (LVD), 2014/30/EU (EMC), 2011/65/EU (RoHS II)
Reference to harmonized standards: EN12418:2000+A1:2009, EN61029-1:2009+A11:2010, EN60335-
48
Polyamide
Steel
Alluminio
Copper
Battipav srl
Epoxy Resin
Publicité
