Battipav EXPERT Mode D'emploi page 44

GB
a) loosen the left leg locking pin (motor side);
2 b) lift the leg and put it in the wheel support
c) block the leg with its locking pin
2 d) tighten the wheel support setscrew
e) repeat the operation for the right leg.
IN ORDER TO FACILITATE THE ELITE MACHINE MOVEMENT IN THE YARD, WE RECOMMEND LOWERING IT UNTIL
THE LOWERED POSITION.
a) loosen the leg locking pins on the front side, one at a time, holding the machine from the transport handles;
b) lower the machine front side, making the legs slide inside the supports until the leg middle hole matches
the hole of the supports;
c) lock the legs by means of the relevant leg locking pins;
3
d) repeat the operations indicated in points (a), (b), (c) for the rear side (motor side).
4
MOVE THE MACHINE AS INDICATED IN PICTURE 4
POSITIONING
Place the machine on a stabile surface.
To place the machine in working position, proceed as follows:
MAKE SURE THAT THE MOTOR HEAD IS LOCKED IN THE LOWERED POSITION BY MEANS OF THE LOCKING LEVER LOCATED
ON THE MOTOR SIDE.
MAKE SURE THAT THE SLIDING CARRIAGE IS LOCKED BY MEANS OF THE CARRIAGE LOCKING STOPPER.
a) put the leg locking pins in release position
5
b) by means of the transport handles, lift the rear side (motor side) until the working position.
5
6
FOR CORRECT MACHINE POSITIONING, MAKE SURE THAT THE LEG UPPER HOLE MATCHES THE LEG
COUPLING HOLE, BEFORE FINALLY LOCKING IT (SEE PICTURE 6).
c) lock the legs one at a time.
6
HOLD THE MACHINE DURING THE LOCKING PHASES.
d) Repeat the operation for the opposite side;
5
IF THE LEGS ARE COMPLETELY REMOVED, PUT THEM BACK WITH THE 4 HOLES DOWNWARDS AND OUTWARDS.
e) Release the working table by means of the locking pin;
7
7 f) Move the working table backwards;
8 g) Turn the rear splash guard.
h) Remove the blade cover tie rod locking screw;
8
i) Turn the blade cover until moving the water on-off tap;
9
10 l) Lever the blade cover so that the blade cover tie rode can pass easily.
m) Put the blade cover tie rod in position;
10
n) Lock the blade cover tie rod with the screw provided that had been previously removed;
11
11 o) In case of difficulty in engaging the screw, move the blade cover slightly.
p) Engage the water hose on the water on-off valve and place the rear splash guard back in position;
12
q) With a 6 mm Allen wrench, secure the working table handle;
13
CHECKING BEFORE USE
14 • Before any cutting operation, make sure that the water level inside the tank is the same as the one indicated
in the picture.
THE EXPERT MACHINE HAS BEEN DESIGNED FOR WORKING WITH WATER.
15 • Make sure that the power supply cable does not interfere with the cutting operations.
Use the cable lock lever to direct its passage.
BEFORE USING THE MACHINE, CHECK THERE IS POWER SUPPLY.
CONNECTING TO POWER SUPPLY
44
Battipav srl