GB
pressing its central pin.
(EXPERT 400):
7) LASER MARKER
It projects the cutting line on the table. It is enabled when the machine is connected to the mains.
CUTTING ON THE TABLE
BEFORE PERFORMING THE CUTTING OPERATIONS, MAKE SURE THAT THE MATERIAL IS PROPERLY LEANED
AGAINST THE TILE STOPPER.
21
BEFORE STARTING THE CUTTING OPERATIONS, THE OPERATOR MUST MAKE SURE THAT AT LEAST 150 cm ARE
LEFT FREE AROUND THE MACHINE (Pos. 2 Picture 21). IN ORDER TO WORK IN SAFETY CONDITIONS, DO NOT LET
OTHER PEOPLE REMAIN NEAR THE MACHINE DURING THE CUTTING OPERATIONS. THE OPERATOR STANDS IN
THE WORKING POSITION (Pos. 1 Picture 21) DURING THE DIFFERENT MACHINE OPERATION PHASES.
By means of the locking lever, secure the motor head
22
• Arrange the piece to be cut on the working table at the desired measurement.
23
• Start the machine and wait until cutting blade cooling water comes out, adjusting the necessary amount by
means of the water on-off valve located on the blade guard
25
• Start the machine and wait until cutting blade cooling water comes out, adjusting the necessary amount by
means of the water on-off valve located on the blade guard.
24
In order to carry out any diagonal cutting, lean the piece against the square as indicated in the picture and go
on with the cutting operation.
CUTTING ON THE TABLE IN 2 PASSAGES
By adjusting the position of the cutting head using the locking lever, it is possible to cut materials of a height of up to 130 mm in 2 passages.
26 27
Put the motor head in position as indicated in the picture in order to take advantage of maximum cutting
capacity.
• By means of the cutting square, arrange the piece to be cut on the working table at the desired measurement.
28
• Start the machine and carry out the first cut.
29
• Turn over the piece 180°, and repeat the cut.
40
WITH THE SIDE STOP IT IS POSSIBLE TO LOCK THE TABLE IN ADVANCED POSITION.
LASER MARKER
CLASS I LASER INSTRUMENT
By means of the laser marker accessory, the cutting operations can be accelerated.
As a matter of fact, the special laser system is able to indicate the tool cutting line on the working table.
THE LASER MARKER STARTS WORKING ONCE THE MACHINE IS CONNECTED TO THE POWER SUPPLY.
DIRECT EXPOSURE TO SUNLIGHT MAY REDUCE THE LASER MARKER EFFECTIVENESS.
IT IS THEREFORE ADVISABLE TO USE THE MACHINE INDOORS.
31
CUTTING WITH LASER MARKER
•
connect the machine to the power supply;
•
position the piece to be cut making sure that the line indicated by the laser marker matches the reference on the
material to be cut;
•
perform the cutting operation as indicated in the paragraph: "CUTTING ON THE TABLE".
DO NOT MODIFY THE MARKER POSITION BY TURNING THE BEAM TOWARDS THE OPERATOR'S EYES. DO NOT
GAZE AT THE BEAM WITH THE NAKED EYE OR LOOK DIRECTLY WITH OPTICAL INSTRUMENTS.
MARKER ADJUSTMENT
In case the marker is not aligned with the cutting line, its correct alignment can be adjusted.
In order to correctly position the marker, proceed as follows:
30
• loosen the three bulb locking screws so that it can be moved;
31
• position a reference properly on the tool cutting line;
• insert the 5 mm Allen wrench provided in the hexagonal slot located on the bulb;
30
• using the Allen wrench, turn the bulb until aligning the mark with the tool cutting line
30
46
Battipav srl