Toto LPT960.8 Manuel D'installation page 5

3) Install the faucet and drains (not sup-
plied) per the manufacturer's installation
instructions.
NO TE: For 8" widespread faucet
fixtures, only install the spout as-
sembly at this time. The hot & cold
faucet valves can be installed at a
later time.
Screw the bolts to the pre-drilled holes
in the wall (see Illustration 4). Leave
1-1/4" of the bolts protruding from the
wall. Place the lavatory into position on
the pedestal with the mounting holes
sitting on the protruding bolts, match-
ing the marks on the wall. Place a slot-
ted flat metal washer onto the bolts and
tighten the bolts to secure the lavatory
to the wall.
DO NOT OVERTIGHTEN. Over-
tightening may damage the prod-
WARNING
ucts and cause personal injury and/
or property damage.
NO TE: You may install the 8" wide-
spread hot and cold facuet valves at
this time.
4) Connect the water supply to the faucet according to the faucet instruc-
tions. Connect and tighten the trap to the drain.
Turn on the water supplies to the faucet. Purge the air from the hot and
cold water by running the water for a few seconds.
Fill the lavatory with water. Check the leaks at the water supply and drain
connections.
Illustration Procedure (continued)
Ill. 4
5