Publicité
Les langues disponibles
Les langues disponibles
˜ Emptying the dust container
INFO:
Empty the dust container
possible, since emptying can lead to a cloud
of dust.
Empty the dust container at regular intervals.
Otherwise the product could be damaged.
1. Press the dust container release
dust container from the product using the
handle
(Fig. J).
[
5 ]
2. Hold the dust container over a waste bin.
3. Press the bottom release
the dust container to open the bottom and
thus discharge the dust (Fig. K).
4. Close the bottom. The bottom release must
audibly lock in place.
5. Insert the dust container into the product. The
dust container release must audibly lock in
place (Fig. L).
˜ Cleaning and care
m
DANGER! Risk of electric shock!
Disconnect the power plug
socket-outlet before cleaning the product.
Never touch the power plug with moist or
wet hands.
Always keep the power plug and power
cord dry.
m
WARNING! Risk of electric shock!
Never immerse the electric parts of the
product in water or other liquids. Never hold
the product under running water.
ATTENTION! Do not use any tools to clean
m
the filters. Otherwise the filters could be
damaged.
ATTENTION! Never use the product
m
without the HEPA filter and motor filter
Otherwise the product could be damaged
and the suction power could be decreased.
1. Switch off the product and disconnect the
power plug from the socket-outlet.
2. Press the hose release
hose
out of the intake
1 ]
[
Do not use any corrosive or abrasive
o
cleaning agents.
12 GB/IE/NI
outdoors if
4 ]
[
. Lift the
[
6 ]
on the side of
23 ]
[
from the
[
9 ]
.
[
10 ]
and pull the
[
21 ]
(Fig. M).
[
13 ]
Remove coarse dirt by hand.
o
Clean the product with a damp cloth. For
o
stubborn dirt, use a damp cloth and a mild
detergent and clean the product again.
Dust container and HEPA filter
(Fig. N)
1. Remove the dust container
(see "Emptying the dust container").
2. Pull up the lid lock (top)
lid.
3. Pull out both cylinders from the dust container
.
[
4 ]
4. Separate the cylinders from each other.
To do this, turn one of the cylinders
counterclockwise.
5. Use a damp cloth to clean the dust container
and the two cylinders. You can also rinse the
dust container and cylinders under running
water.
6. Pull the filter frame out of the lid.
7. Remove the foam inlay
8. To remove dust, tap the filter frame.
9. If necessary, rinse the filter frame and the
foam inlay under running water. Let the parts
dry completely at a location without direct
sunlight.
Motor filter
(Fig. O)
INFO:
Clean the motor filter
normal use, it is recommended to clean the
motor filter every 6 months.
1. The motor filter is located behind the air
outlet grille
. Slide the grille lock
25 ]
[
left. At the same time pull out the air outlet
grille.
2. Carefully press down the lock on top of the
filter frame. Pull out the filter frame.
4 ]
[
. Open the top
3 ]
[
.
24 ]
[
if it is dirty. With
10 ]
[
to the
26 ]
[
Publicité
