Publicité
Les langues disponibles
Les langues disponibles
Use the product on a solid, level surface
only. Using the product on an unstable or
uneven surface – such as a gravel surface –
may lead to the load slipping.
Ensure that you never exceed the
allowable (rated) load capacity.
2000
kg
The person operating the jack must observe
the jack and the load during all movements.
Never work under the raised load if it has
not been made secure by suitable means.
Do not allow the hydraulic vehicle jack to
be used by uninstructed or inexperienced
persons.
Before using the hydraulic vehicle jack take
precautions to prevent the vehicle from rolling
away. Put the handbrake on, place the vehicle
in gear (with automatic gearboxes set to "P")
and chock the wheels.
Even with safety measures in place always
remain alert and make a visual check that
the support plate
is firmly seated against
3
the vehicle jacking point.
Make sure that no petrol, battery acid or
any other dangerous substance can flow out
of the vehicle when the vehicle is being lifted.
Check that no person or object is under the
vehicle before you lower it.
Lower the vehicle slowly.
Check that all parts have been assembled
and fitted properly and are undamaged.
Before each use check that the hydraulic
vehicle jack is working properly. Check the
screws and valves of the hydraulic vehicle
jack for correct seating and look out for
hydraulic oil leaks in particular.
Never use the hydraulic vehicle jack for
moving or loading a vehicle. Never use it to
lift a whole vehicle completely off the ground.
It's not allowed to lift up people with the
hydraulic jack and make sure that near
located people keep enough distance to
the vehicle when the hydraulic jack is in use.
Never change the setting of the safety val-
ve
. It has been set at the factory and must
8
not be adjusted. Stop using the product if the
safety valve setting is changed.
Before using the vehicle jack, the user must
be made familiar with the device by an expe-
rienced person. The pump force and the
transferred force are equal to approximately
350 N.
If the markings on the product are damaged
enough so as to be illegible then the vehicle
jack must not be used until the markings are
renewed.
No modifications may be carried out to
the hydraulic trolley jack. Any physical mod-
ification of the device has an effect on the
safety of the device and its compliance with
EN 1494 / A1:2008.
The applied force when using the vehicle
jack must be lower 350 N. The equates to a
force on the lever of approximately 35 kg.
The operating temperature of the hydraulic
oil of this equipment is between -20 °C to
+40 °C.
Only use this device to lift and lower the
vehicle, not to keep the vehicle in a lifted
position. Do not move it whilst raising or
lowering.
After use return all parts used into their
original position. Have the hydraulic oil or
oil pump replaced by a professional if the
parts can no longer be moved.
If you notice a spillage of oil, stop using the
product and absorb the oil on the floor with
a cloth. Any reparation must be done by a
professional.
If the jack can not be lowered as wished, the
car must be secured by jack stand against
unintended lowering. Get a new jack, with
which you can lift the car, so that the defect
jack can be removed. If you are unsure,
please ask for professional help.
Before first use
Assembling the
carrying handle
The carrying handle
4
2 different position, see Fig 1 and 2.
can be attached in
GB/IE/NI
7
Publicité
