Kartsana CS-200 Serie Manuel D'utilisation page 34

Instruction manual
Chair-stretcher CS-200
2.2.5. Safety belts
A
B
C
Belt knot
34
F
G
D
E
Place female buckle A and male buckle B in the
position shown in the side figure and insert the
A
tension the assembly by adjusting the tension
B
Place the fasteners (C) in the position
shown in the figure above. Pass the
male buckle (D) between the latches
(C) until it locks into buckle B. Once
the assembly is secured, centre and
tighten the assembly by adjusting the
belt tension at the ends A, E, F and/or
G. (The latches C do not appear on the
latter into the groove of the former.
Once the assembly is secured, centre and
of the belt using end C.
C
It is recommended that the patient
is always secured with safety belts
during the time he or she is on the
stretcher.
Head belts:
foot belt).
Lap and leg belts:
REV 1
06-24