Ryobi RRS1200-K Traduction Des Instructions Originales page 4

Press the saw blade into the saw blade holder up to the
stop. Make sure that the saw blade is fixed securely.
OPERATION TIPS
You may cut metals such as sheet steel, pipe steel rods,
aluminum, brass, and copper with the product.
WARNING
Be careful not to twist or bend the saw blade.
Do not force the product.
Use cutting oil when cutting soft metals and steel.
Cutting oil also keeps the blades cool, increases cutting
action, and prolongs blade life.
Never use gasoline since normal sparking of motor
could ignite fumes.
Clamp the workpiece firmly and cut close to the
clamping point to eliminate any vibration of the work.
When cutting conduit pipe or angle iron, secure the
workpiece with a vise, if possible, and cut close to the
vise. To cut a thin-sheet material, place the material
between two hardboards or plywood and clamp the
layers to eliminate vibration and material tearing.
Always keep firm pressure on the base to hold it
securely against the workpiece.
Do not use cracked or distorted saw blades. Do not use
saw blades that are damaged or deformed.
WARNING
Dust from certain paints, coatings, and materials may
cause irritation or allergic reactions. Dust from wood
such as oak, beech, MDF, and others are carcinogenic.
Materials containing asbestos should only be worked on
WARNING
Always wear safety goggles or safety glasses with
side shields when operating the product. Failure to do
MAINTENANCE
WARNING
The product should never be connected to a power
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product will prevent
WARNING
When servicing, use only original manufacturer's
replacement parts. Use of any other parts may create a
hazard or cause product damage.
2 | English
WARNING
For greater safety and reliability, all repairs should be
performed by an authorised RYOBI service centre.
WARNING
Always wear safety goggles or safety glasses with
side shields when operating the product. Failure to do
If the power supply cord is damaged, it must be replaced
only by the manufacturer or by an authorised service centre
to avoid a safety hazard. Contact authorised service centre.
When changing the saw blade, ensure that the saw blade
holder is free of material residue, such as wood or metal
shavings.
GENERAL
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
WARNING
based products, and penetrating oils, come in contact
with plastic parts. They contain chemicals that can
damage, weaken, or destroy plastic.
chips and grindings are highly abrasive to bearings,
brushes, and commutators. We do not recommend using
the product for extended periods of time on these types
of materials.
WARNING
Do not use compressed air to blow dust from the product.
This practice is dangerous and can cause dirt and grit to
LUBRICATION
All of the bearings in the product are lubricated with a
the product under normal operating conditions. Therefore,
no further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories, and
packaging should be sorted for environment-
friendly recycling.