Publicité
Les langues disponibles
Les langues disponibles
M A I NTE N A N C E
CLEANING
BEFORE CLEANING THE APPLIANCE ALWAYS TURN IT OFF AND DISCONNECT
FROM POWER SUPPLY AND WAIT UNTIL IT HAS COOLED DOWN.
EK2000SX
SURFACES THAT ARE STILL HOT CAN BE DAMAGED IF THEY COME INTO
CONTACT WITH COLD WATER OR A DAMP CLOTH.
NEVER USE ABRASIVE, CORROSIVE OR CHLORINE BASED CLEANING
PRODUCTS. NEVER USE STEEL OR PLASTIC SCOURING PADS. NEVER LEAVE
DEPOSITS OF ACID OR ALKALINE SUBSTANCES (VINEGAR, SALT, LEMON JUICE
ETC.) ON THE APPLIANCE. STAINLESS STEEL OR ENAMELLED SURFACES MUST
BE CLEANED ONLY WITH WATER AND SOAP OR A NEUTRAL DETERGENT,
THOROUGHLY RINSE AND DRY. USE CLEAN SPONGES OR CLOTHS TO CLEAN.
INJECTORS
CLEANING OR REPLACING GAS INJECTORS MUST ONLY BE PERFORMED
BY AUTHORISED AND QUALIFIED GAS SERVICE ENGINEERS. THE
MANUFACTURER DECLINES ALL RESPONSIBILITY IN REGARD.
(FIG.4 - PAG. 125)
B
A
BURNER
A
B
C
C
Ø INJECTOR (mm)
0,57
0,57
0,69
EK2000DX
B
C
A
STAMPED N.
57
57
69
Publicité
