Dometic HBH2000L Manuel D'installation page 13

I N STA LL ATI O N
SAFETY WARNINGS
WARNING: THIS WARNING IS AFFIXED TO THE APPLIANCE. THIS
APPLIANCE MUST BE INSTALLED IN ACCORDANCE WITH REGULATIONS IN
FORCE AND ONLY USED IN AN ADEQUATELY VENTILATED AREA. ALWAYS
READ THE INSTRUCTIONS PROVIDED IN FULL BEFORE INSTALLING
AND USING THIS APPLIANCE. THIS APPLIANCE MUST BE INSTALLED BY
SPECIALIST GAS SERVICE ENGINEERS.
THIS APPLIANCE IS DESIGNED AND MANUFACTURED FOR COOKING
FOOD ONLY. ANY OTHER USE IS CONSIDERED IMPROPER AND INCORRECT
CREATING HAZARDOUS CONDITIONS. THE MANUFACTURER DECLINES
ALL RESPONSIBILITY FOR DAMAGE TO THINGS OR INJURIES TO PERSONS
CAUSED BY INCORRECT INSTALLATION AND / OR INCORRECT AND
IMPROPER USE.
BEFORE INSTALLING CHECK THAT THE LOCAL GAS AVAILABLE (GAS TYPE
AND PRESSURE) AND THE APPLIANCE REGULATORS ARE COMPATIBLE WITH
THE APPLIANCE ITSELF.
GAS REGULATING SPECIFICATIONS FOR THIS APPLIANCE ARE PROVIDED ON
THE LABEL AFFIXED TO THE APPLIANCE (OR ON THE SERIAL PLATE).
THIS APPLIANCE IS NOT CONNECTED TO A FUME EXTRACTION FLUE
FOR EXTRACTING PRODUCTS OF COMBUSTION THEREFORE IT MUST BE
INSTALLED AND CONNECTED (FITTED) CONFORMING TO INSTALLATION
REGULATIONS IN FORCE FOR APPLIANCES OF THIS TYPE. IT IS OF UTMOST
IMPORTANCE TO RESPECT LEGISLATION REGARDING VENTILATION.
CABINET APERTURE
THE APPLIANCE MUST FITTED AT AN APPROPRIATE AND SAFE DISTANCE
FROM FLAMMABLE MATERIALS.
This hob has a class 3 grading: BUILT-IN APPLIANCE FOR KITCHENS OR WORKTOPS
MINIMUM ALLOWABLE DISTANCES FROM WALLS (FIG. 1 - PG. 122):
A / B FROM THE OUTER EDGE OF THE BURNER HEAD NEAREST ONE OF THE SIDE WALLS AND / OR
REAR WALL:
135 mm
C THE DISTANCE BETWEEN THE TOP OF THE BURNER AND THE BOTTOM OF THE UNITS AND /
OR SHELVES FITTED ABOVE THE HOB:
500 mm
D THE DISTANCE BETWEEN THE BOTTOM OF THE BURNER AND THE UNDERSIDE:
30 mm
SIZE OF CABINET APERTURE
Cut-out a hole in the cabinet as illustrated in FIG. 2 - PG. 123 depending on model to install.
The cabinet must be appropriately constructed and aligned horizontally with the worktop and with the unit.
The cabinet aperture must be perfectly squared and aligned.
If there are apertures for cabinet ventilation, prevent flammable materials from entering these.