Publicité
Les langues disponibles
Les langues disponibles
MIG-160ERS
- Connect the cable inside the device to the "-" pole (8)
- Connect the earth cable to the socket (9) with positive polarity.
Synergic FUNCTION
The SYN light only lights up when the program is in MIG mode, it doesn't light up when in MMA mode.
The button regulates the voltage by default, depending on how the amps are set. It is possible to set a
deviation (button 5) of the voltage from -10 to +10, depending on which end result is more suitable for
your desired weld seam.
MMA Welding
Connect the welding cable and the earthing cable to the socket (8, 9) with the appropriate polarity
according to the electrode manufacturer's recommendation.
Pay attention to positive and negative attachment. Different types of electrodes require different
polarities, see electrode manufacturer's instructions.
* In TIG mode (LIFT TIG), connect the cables in the same way as in the case of "A rutile
electrode ".
Polarity:
The polarity depends on the information provided by the electrode manufacturer on the electrode
packaging.
Electrode NEGATIVE / workpiece POSITIVE - low-alloy rutile electrode types. (These are the most
commonly used)
Electrode POSITIVE / workpiece NEGATIVE - basic and high-alloy electrode types.
Connect the power cord to the appropriate voltage and power source and ensure the cord is secure.
The device can now be switched on by operating the on/off switch on the back and thereby putting it
into operation.
Electrode Welding
Electrode welding or MMA welding is one of the oldest welding processes that uses stick electrodes that
protect the melt from chemical reactions with the ambient air. In this process, an arc burns between an
electrode and the workpiece, melting the electrode into a filler material.
Electrode Diameter
11
Publicité
