Publicité
Les langues disponibles
Les langues disponibles
Power and Sound Controls continues
AUX Jack
Selecting Auxiliary Source
C) Press AUX to select AUX Input mode.
Ci 1 MM
MBA
(2) Connect the auxiliary equipment (an optional DCC player deck or any
other appropriate equipment) to the AUX Jack.
Canceling AUX Input mode Ñ E
a
TAN AT
ere
Press AUX or MODE again while the AUX mode is operated, the
mode will return to the previous mode. Or insert a cassette tape, and
the mode will change to TAPE mode.
Note: The AUX mode enables setting of VOL, BAS, and FAD, inde-
pendently of other modes.
Programmed Sound Memory
Mode Selection
A desired sound setting (except for VOL and ATT) can be memorized
and recailed.
Sound Memory Input
e Press SDM to select the sound memory mode.
e To preset a desired sound level, press the corresponding preset
memory button (1 to 4) for more than 2 seconds in sound memory
mode.
iin TE
Ld
LILIM à
1
e The preset memory buttons 5 and 6 are not valid for sound memory.
Recall Sound Memory Call
è When a desired preset memory button is pressed in sound memory
mode, the corresponding sound setting is called.
GAL
e The preset memory button 5 is recommended for setting.
|
e The preset memory button 6 is used to release all sound settings.
A-MIN1/2" LONG (12mm)
Caution:
B-MAX2/5" DIA. (10mm)
in order to insert the plug into the "AUX" Jack proper-
C-MIN 1/8" DIA. (3.5mm)
ly, make sure to use the correct size of the stereo
plug shown on the left.
CO-R925EUC
Publicité
