Panasonic CQ-R925EUC Manuel D'utilisation page 14

Cassette Tape Player Basics continued
TPS Operation (Tape Program
Search)
(D Press 3 (TPS) to activate the tape program search mode.
TPG PLAY "^
(2 From the current selection, decide which program you want to select.
Now, press =>" several times forward (up to 9 programs) or press
"e several times backward (up to 8 ) to select the corresponding
program number.
(Fast forward:) (Rewind:)
| -------------P 9) ------------- PB
t + tf 4
EX1. To select the current program again
press 3 (TPS), and press "e once.
EX2. To select the 1st program backward
of the current selection, press 3
(TPS) once, and press "<<" two
times.
EX3. To select the next program, press 3
(TPS) and press >>" once.
EX4. To select the 3rd program forward of
the current selection, press 3 (TPS)
once, and press "»»" three times.
© To turn it off, press 3 (TPS) again.
Note:
The TPS mode may not work correctly in the following cases. This, however, does not mean that the unit
is defective.
e There is an interval less than 4 seconds or having a high level of noise or hum between programs.
e There is particularly low-level passage during the program.
Notes on Cassette Tapes
Label
Pencil
Exposed end
Use a pencil or similar object to take up the slack as
shown. If a loose tape is used, this may result in the
tape becoming tangled in the rotating parts of the Do not
unit. touch or
pull out the
tape.
14
CQ-R925EUC