Technical Data; Before Starting The Equipment; Items Supplied; Intended Use - EINHELL WW 2000 D Mode D'emploi D'origine

Anleitung_WW_2000_D_SPK7__ 28.04.14 14:44 Seite 11
Caution – Some parts of the product can
n
become very hot and cause burns. Special
care is required when children and persons
in need of protection are present.
Danger!
Read all safety regulations and instructions. Any
errors made in following the safety regulations and
instructions may result in an electric shock, fire and/or
serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1
)
1 LCD
2 Function buttons
3 ON/OFF main switch
4 Foot
5 Protective grille
6 Remote control

3. Items supplied

Open the packaging and take out the equipment
n
with care.
Remove the packaging material and any
n
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
n
Inspect the equipment and accessories for
n
transport damage.
If possible, please keep the packaging until the
n
end of the guarantee period.
Danger!
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
Heater
n
Remote control
n
Installation material
n
Original operating instructions
n

4. Intended use

The equipment is designed for use as an additional
heater in enclosed areas. It primarily emits heat by
radiation straight on to objects and people who are in
front.
The appliance can be used indoors in a free standing
position or mounted on a wall. Maintain all minimum
distances. The appliance may only be used
completely assembled and standing vertically.
The appliance may only be used for the tasks it is
designed to handle. Any other use is deemed to be a
case of misuse. The user/operator and not the
manufacturer will be liable for any damage or injuries
caused as a result thereof.

5. Technical data:

Rated voltage:
Heat output: 2000 W (1250 W / 2000 W)
Adjustment range of thermostat:
Protection type:

6.1 Before starting the equipment

6.1 Assembly
Warning!
6.1.1 Free-standing installation (Fig. 2)
Observe section 1 "Safety regulations".
To prevent damage when attaching the feet to the
heater, place the heater upside down on a soft
surface (e.g. a carpet).
Fit the two feet (4) to the housing, each with one
screw (A).
6.1.2 Mounting on a wall (Fig. 3)
Observe point 1 - Safety information.
Do not attach the feet if the equipment is to be
n
mounted on the wall.
Caution! Make sure that there are no electric cables
or other installations (for example water pipes) near
the drill holes. Ensure that the equipment is secured
firmly and horizontally to the wall. Use only suitable
fastening material on a wall capable of bearing the
load.
The supplied dowels and screws are suitable for the
following: Concrete, natural stone with a dense
structure, solid brick, solid limestone bricks, solid
lightweight concrete bricks and aerated concrete (gas
concrete). It is essential to observe the minimum
distances (Fig. 4 and point 1 – Safety information).
GB
220 - 240 V ~ 50 Hz
7 – 30 °C
IP 24
11