Publicité
Les langues disponibles
Les langues disponibles
Lifting
• Insert the hexagonal bit in the drill chuck. The cardan supplied
is only for Iifting with the crank.
• Place the drill in its holder, inserting the hexagonal bit in the
control shaft in the housing. Tighten the drill with the knob an
the holder.
• Operate the drill (direction of rotation to the right) holding it
firmly.
• Before reaching the maximum height, slow the Iifting speed. Do
not exceed the maximum height marked by the red line an the
telescopic arm located on the side.
• Tighten the anti-tilt arm Ieeking mechanism.
• Check that the vehicle is stable before working underneath it.
It must not be able to slip or tilt, even if the user should push
against it while working. If there is a risk of the vehicle tilting,
re-lower the Mini Lift and move it so as to place more weight an
the wheels which remain on the ground.
• Install the safety jack stands before working under the vehicle.
It is also possible to Iift or lower the Ioad using the crank and the
cardan supplied.
– 26 –
Publicité
