Publicité
Les langues disponibles
Les langues disponibles
Safety Measures
The Mini Lift must be operated with an electric drill which has a
sufficient torque (90 Nm). The use of impact wrenches, air bolt
removers or striking tools is strictly forbidden because of the
damage which could be caused to the drives.
Use on a flat, hard, smooth floor (for example, concrete). A rough
floor can hinder the working of the Mini Lift, by putting up too
much resistance to the movement of the castors.
Before Iifting or lowering the Ioad, systematically check that the
obstacles preventing the descent (jack stands and anti-tilt arm)
are removed.
The warranty does not apply if the safety instructions and the
safety measures are not followed.
Range of operating temperatures: -10 / +50 °C
Load limitiation
The connecting hexagon bit between the drill and the Mini Lift
acts as a protection in the event of excessive Ioad or when the
maximum height is reached. In these Situations, the breaking of
this hexagon bit is normal. Replace this hexagon bit with a new
pin, then continue using, making sure that the instructions for
maximum Ioad and height are followed.
The Mini Lift is fitted with end stops, for the maximum Iift position
– 20 –
Publicité
