ResMed AirFit F30i Mode D'emploi page 6

Cleaning your mask
If there is any visible deterioration of a mask component (cracking,
crazing, tears etc.) the component should be discarded and replaced.
Daily/After each use: Cushion
Weekly: Headgear, frame and elbow
1. Soak the components in warm water with a mild liquid detergent.
2. Hand wash the components with a soft bristle brush. Pay particular
attention to the vent holes in both cushion and elbow.
3. Thoroughly rinse the components under running water.
4. Leave the components to air dry out of direct sunlight.
If the mask components are not visibly clean, repeat the cleaning steps.
Make sure that the vent holes and anti-asphyxia valves are clean and
clear.
Reassembling your mask
1. Align and insert the frame connector tab (a) into the cushion slot (b)
and press down until it clicks. Repeat on the other side.
2. Attach the elbow to the top of the frame until it clicks.
3. With the ResMed logo facing outwards and up, insert the upper
headgear straps into the frame from the inside and fold the fastening
tabs over to secure.
Note: If the elbow ring detaches, re-insert into the top of the frame.
English 5