For Your Safety; Tool Specifications; Operating Controls - Würth Master S 50 TB Notice Originale

GB
Working safely with this machine is
possible only when the operating and
safety information are read completely
and the instructions contained therein
are strictly followed. In addition, the
general safety notes in the enclosed booklet must
be observed. Before using for the first time, ask
for a practical demonstration.
The unit must not be damp and must not
be used in a wet environment.
Wear hearing protection. Exposure to
noise can cause hearing loss.
Before each use of the machine, check
the machine, cable and plug. Have
repairs carried out only through the
Würth Master-Service or by a qualified
technician. Insert the plug into the
socket only when the machine is
switched off.
When working with the machine, always hold
it firmly with both hands and provide for a
secure stance. The power tool is guided more
secure with both hands.
Do not work materials containing asbestos.
Asbestos is considered carcinogenic.

Tool Specifications

Dry Wall Screwdriver
Order number
Rated input
Output
No-load speed
Tool holder
Screw Ø
Torque at rated load
Weight approx.
Protection rating

For Your Safety

For further notes on safety refer to enclosed sheet.
S 50 TB
0702 050 X
500 W
255 W
0 – 4 650 r.p.m.
1/4 "
5.0 mm
0.67 Nm
1.5 kg
/ II
Always wait until the machine has come to a
complete stop before placing it down. The tool
insert can jam and lead to loss of control over
the power tool.
Hold the machine with a firm grip. High reac-
tion torque can briefly occur while driving in
and loosening screws.
Do not use a machine with a damaged mains
cable. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working.
increase the risk of an electric shock.
Connect machines that are used in the open
via a residual current device (RCD).
Use suitable detectors to determine if utility
lines are hidden in the work area or call the
local utility company for assistance.
Contact with electric lines can lead to fire and
electric shock. Damaging a gas line can lead to
explosion. Penetrating a water line causes
property damage or may cause an electric
shock.
Hold the machine only by the insulated grip-
ping surfaces, when performing an operation
where the cutting tool may run into hidden
wiring. Contact with a "live" wire will make
exposed metal parts of the tool "live" and shock
the operator.
Use only original Würth parts and accesso-
ries.

Operating Controls

1 Screwdriver bit
2 Bit stop
3 Bit holder
4 Adjustment ring for depth stop
5 Belt hook
6 Selector switch for clockwise and anti-clockwise
rotation
7 Lock-on button for continuous operation
8 ON/OFF switch
9 Mains cable module
10 Latch, mains cable module
Not all of the accessories illustrated or described are included
as standard delivery.
Damaged cables
7