Lotus PCQ-94ET Instructions Pour L'installation Et L'emploi page 29

GB IE
IT CH
Before starting to clean the appliance, disconnect the power supply. The parts in steel must be washed with hot water
and neutral detergent, then rinsed thoroughly in order to eliminate all traces of detergent; after which, dried with a dry
cloth. Do not use abrasive or corrosive detergents.
Cleaning the crystal
The crystal must be cleaned with degreasing liquids, acids containing vinegar and lemon, suitable for cleaning ceramic
and crystal. It is advisable to carry out this operation when the crystal is not completely cold, so that spilled food,
burned grease, etc. can be softened using a damp cloth and removed whilst still warm with an ordinary scraper, in order
to avoid damaging the crystal surface.
Do not use abrasive or corrosive detergents.
PROCEDURE TO FOLLOW IF THE APPLIANCE IS NOT GOING TO BE USED FOR
SOME TIME
Clean and dry the appliance carefully according to the instructions. Disconnect the power supply.
PROCEDURE TO FOLLOW IN THE EVENT OF A BREAKDOWN
In the event of breakdown, turn off the appliance, disconnect the power supply by using the device situated above the
appliance and notify the after sales service.
MAINTENANCE (ONLY FOR QUALIFIED PERSONNEL)
Any kind of maintenance must only be done by qualified personnel. Before carrying out maintenance, remove the plug
or switch off the switch above the appliance.
ACCESSIBILITY
To get to the junction-box, remove the front panel of the appliance. The control elements are reached from the front
control panel; unscrew the fixing screws from the control panel and remove it.
29