Dogtra T&B DUAL Manuel Du Propriétaire page 9

Pitch Setting Button
You can change the pitch of the beeper by pressing the
Pitch Setting button, the bottom button on each side of
the transmitter. The speaker with one bar will be the low
pitch, while the speaker with three bars will be the high
pitch. See the figure below.
Button not pressed Button pressed
(low pitch)
When the Pitch Setting is set on low pitch, the beeper
will emit a double beep when it is in Run/Point mode or
Point-Only mode. If the Pitch Setting is set on high pitch,
the beeper will emit a single beep when it is in Run/
Point or Point-Only mode.
16
Button pressed
(high pitch)
2) Training Setting
2nd Dog
Nick/
Constant
HPP
Vibration
Locate
You can use the Setting
Toggle Switch on the back
of the transmitter to change
from B (Beeper Setting) to
T (Training Setting). The
Training Setting offers Nick/
Constant, HPP Vibration, and
Locate functions.
1st Dog
Nick/
Constant
HPP
Vibration
Locate
17