Dogtra T&B DUAL Manuel Du Propriétaire page 14

Follow the steps below to charge your system:
1. Open the rubber plugs on the battery charging
receptacles and plug in the charging cable.
2. Plug the charger into a 120-volt wall outlet or, if using
the auto charger, plug into a cigarette lighter only for
lithium polymer batteries (use a 220 volt European
charger for Europe). All indicator lights should glow
red when properly plugged in and the unit will
automatically shut off during the charging process.
You will need to turn the unit on again before use
once the unit is fully charged and unplugged from the
battery cable.
3. The lithium polymer battery is fully charged within
2 hours. The lights will stay red during the charging
process and turn green once the unit is fully charged.
4. After charging, cover the battery charging receptacles
with the rubber plugs.
26
8. Handheld Transmitter OLED
Setting Mode
Battery
1st
Dog
2nd
Dog
The OLED screen indicates the stimulation level on the
screen ranging from (0-127). The battery life indicator
shows:
3 bars = full charge
2 bars = medium charge
1 bar= needs charge
The battery life indicator only shows the remaining
charge of your transmitter. To find the remaining charge
for your receiver, observe the LED indicator light on the
receiver.
Stimulation
Level
27