Dogtra T&B DUAL Manuel Du Propriétaire page 8

Beeper Mode Button (Run/Point & Point-Only)
The middle button is the Beeper Mode button for each
side of the transmitter. When you press the Beeper
Mode button the first time, the receiver will beep twice.
The beeper unit will always start in Run/Point mode.
The beeper will sound every 7 seconds while the dog is
running, and every 2 seconds when the dog is on point
or becomes stationary. The second time you push the
Beeper Mode button, it will beep once and remain silent
while the dog is running and beep every 2 seconds when
the dog is on point or stationary.
To turn the beeper unit off, press the Beeper Mode
button a third time. The unit will emit three rapid beeps,
and the beeper will turn off. The Locate mode can still
be used!
Button not pressed
14
Button pressed
(BEEPER MODE)
Initial Beeper
Mode
Sound
Press Run/Point
2 Beeps
1st Time
Mode
Press Point-Only
1 Beep
2nd Time Mode
Press No Beeper
3 Beeps
3rd Time
Mode
Note: Even if the Beeper Mode is being used, you can
still use the Locate function by changing the Toggle
Switch to Training Setting.
Action
- Dog running/moving: emits
double beep every 7 seconds
- Dog stationary/pointing: emits
double beep every 2 seconds
- Dog running/moving: silent
- Dog stationary/pointing: emits
double beep every 2 seconds
No sound
15