Dogtra 2700T&B Manuel Du Propriétaire page 9

Locate Button
The Locate button is located on the left side. It causes
the receiver's beeper horn to emit a series of beeps when
held down and gives you the ability to keep track of your
dog's location. On one-dog models, the beeper can be
adjusted between high and low pitches.
Note: The high/low pitch is not an option on two dog
units. On two-dog models, the green receiver emits the
high pitch and the orange receiver emits the low pitch
automatically. The pitch cannot be changed.
Pager Button
The Pager button is located on the left side of the
transmitter. Pressing it will give a vibration for as long as
the button is pressed, for up to 12 seconds.
Mode Button
Your 2700T&B has three different modes: Locate, Run/
Point, and Point-Only. The Locate mode can be activated
at any time, even when another mode is set, by pressing
the top orange button labeled Locate on the left side
of the transmitter. To set the beeper unit to Run/Point
and Point-Only mode, press the black Mode button. This
button is located on the right side of the transmitter.
14
2702T&B
Locate
Pager
The two-dog model has a toggle switch on the face
of the transmitter located above the Nick button. The
toggle switch allows for selection of either receiver.
Set the toggle switch on the green position to select the
green receiver and the orange position to select the
orange receiver. The stimulation (Nick and Constant)
along with the beeper and Locate modes will only
operate when the toggle is in the desired position for
the appropriate receiver.
Dog Collar
Toggle Switch
Nick
Constant
On/Off
Button &
Mode
Dog Collar
Toggle Switch
15