Publicité
Les langues disponibles
Les langues disponibles
Battery Charging Procedure
Note : The unit has a partial charge when it leaves the
Dogtra facility. Upon receipt of the collar, be sure to give
it a full 2-hour initial charge before the first use.
1. Attach the charging cables to both the transmitter
and receiver(s), as shown on page 66.
2. Plug the charger into a 120 volt wall outlet or, if using
the auto charger, plug into a cigarette lighter only for
lithium polymer batteries. All indicator lights should
glow red when properly plugged in and the unit will
automatically shut off during the charging process.
You will need to turn the unit on again before use
once the unit is fully charged and unplugged from the
battery cable.
3. The lithium polymer battery is fully charged within
2 hours. The lights will stay red during the charging
process. The red light will turn green once the unit is
fully charged.
4. After charging, cover the battery charging receptacles
with the rubber plugs on the transmitter and receiver.
Note : Only use Dogtra approved batteries, chargers,
and accessories for your Dogtra e-collars. When a
charger is not in use, disconnect it from the power
source.
24
Charger Info
Manufacturer : E-SUN
Manufacturing country : CHINA
Model name : MKC-1001500S
INPUT : 100-240V~50/60Hz 0.4A
OUTPUT : 10V 1500mA
Attention!
During battery charging, the unit must be close to
the wall outlet and the wall outlet must be easily
accessible for security reasons.
25
Publicité
