MRA TN Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA-Windshield
1
2 Balll rods
2 Rod clamps
2 Ball clamps
2 Cover plates
1
4 Flat screws M5x16
4 Allen screws M5x16
8 Nuts M5
2 Washers 12x 5mm
4 Rubber spacer 16x4,5x4mm
2 Allen screws M6x25 bright
2 Screw caps M6 black
2 Rod caps
1. Position the motorcycle on a level surface.
2. Detach the original windshield and fixtures (P.1/P.2); The side fixtures (P.1) are no longer needed.
3. Insert the nuts (7) into the hexagon recesses on the side of the ball clamp (3). Put the Allen screws
(6) through the clamp and screw them into the nuts (do not completely tighten yet) (P.3).
4. Place the rod clamp onto the rod.
5. Attach the ball rod (1) to the fairing panel using the ball clamp (3) and the cover plate (4). Fasten
using the flat screws (5) and the nuts (7). Tighten the screws (P.3).
Position the ball clamps with the heads of the Allen screws pointing inwards (to the centre of the
This is the only way to ensure that you will still be able to tighten the screws after installation.
6. Attach the original front fixture (13) to the fairing panel using the screws (5), washers (8), rubber
spacers (9) and the original nuts (P.4).
7. Position the fairing panel with fixtures on the motorcycle and fasten the original front fixture using
the original screws and the rod clamps (2) using the screws (10) and the rubber spacers (9) (P.5).
8. Tighten all screws.
9. Check screws for proper torque regularly.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
Fixture set (HKST):
Screw set:
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Triumph Tiger 800 XC
Article No..
---
10541
10544
10543
10542
10554
10560
10557
10635
10634
10647
10548
10550
Caution!
vehicle)!
2
Required tools
Allen key 3, 4, 5mm
Torx T30
Ring spanner 8mm
Socket spanner 8mm