Husqvarna BMP 265 Manuel D'utilisation page 12

General product maintenance
BMP 265: Make sure that the power plug and
extension cable are in good condition and
not damaged.
BMP 265Petrol: Make sure that there is no
oil or fuel leak.
To clean the product
• Always clean all the equipment after use. Use a
vacuum cleaner.
• Do not use a high-pressure washer to clean the
product.
• Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
• Clean the tool drum after operation on moist
surfaces.
To change the direction of rotation of
the motor BMP 265
1. Stop the motor. Refer to
11 .
2. Wait until the product is fully stopped.
3. Disconnect the power plug.
4. Turn the inverter switch in the mains plug to the
opposite position.
Scarifying drum
Tools for the scarifying drum
There are different tools for the scarifying drums, Cutters
(A) and Milling cutters (B). The tools are applicable for
different surfaces.
A
B
12
To stop the product on page
Daily 12h after service
*
*
Assembly of the scarifying drum
3
2
1
1. M6x16 hexagon head screw
2. M6 spring lock washer
3. Retaining plates
4. Axle
5. Scarifying drum
6. Scarifying flail or cutter
7. Spacer
To replace the scarifying drum
WARNING:
parts are fully stopped. Pull out the key of
the OPC.
Yearly
5
4
6
7
Make sure that all moving
1814 - 003 - 22.08.2024