Phonocar VM 019 Notice De Montage Et D'emploi page 33

Risoluzione dei problemi
Please consult the following troubleshooting table before contacting a service center.
Familiar characters and their meanings
Error message
No Disc
Bad Disc
Unkown Disc
General problems
Error message
Remote control does
not work.
No sound comes out or
it's hard to hear.
User settings are lost
when the
car is turned off.
TFT Display
Error message
Abnormal display (such
as lines going through
picture)
Garbled characters
Radio Tuner
Error message
Poor radio reception
All manuals and user guides at all-guides.com
Causes
Disc is too dirty.
Disc is inserted upside down.
The disc is not compatible
with the unit.
Causes
Battery has been exhausted.
Battery is not installed correctly.
Audio output connection is not
correct.
The volume level is set to
the minimum level.
The audio channel outputs are not
balanced.
The ACC wire and battery are not
connected correctly.
Causes
The color system of DVD disc is not
suited with the monitor.
The video cord is broken.
The video cord is not connected
correctly.
Unit malfunction
Causes
Antenna not fully extended.
Clean the disc or change the disc.
Insert the disc correctly.
Make certain the disc is clean so that
the unit is reading it correctly. If the disc
is clean, then the unit is simply not able
Install the battery correctly.
Remove the protections
Correct the connection according
to the wiring diagram
Adjust the volume to the optimum level.
Adjust the balance of audio channel outputs.
Please refer to Audio control.
Correct the connection according
to the wiring diagram
Adjust the color system of the DVD disc
Change the video cord.
Connect the video cord correctly.
Turn the unit off and then on again, or change
to a different playing mode, and then back to
the original playing mode.
Fully extend the antenna.
33
Remedies
to play the disc.
Remedies
Change the battery.
Remedies
or the monitor.
Remedies
GB