Husqvarna BGS 250 Manuel D'utilisation page 11

CAUTION:
thin wood below the handle to prevent
damage to the floor.
WARNING:
product is in a stable position before you
replace the diamond tools.
4. Put the special tool (A) through the slots to prevent
movement of the tool plate.
5. Remove dust with the dust extractor.
6. Use a hex key to remove the 4 bolts that holds the
grinding disc.
7. Clean the tool plate with the dust extractor.
8. Attach a new grinding disc (B) and the 4 bolts.
Tighten the bolts with a hex key.
2363 - 003 - 22.05.2024
Put a piece of cloth or
Make sure that the
A
B
CAUTION:
flexible coupling is not damaged.
9. Remove the special tool.
10. Carefully lift the product at the handlebar to
To adjust the handle and the
operation position
handlebar on page 9 .
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do daily maintenance. Refer to
on page 13 .
3. Make sure that the product is assembled correctly
and is not damaged.
4. Put the product on the work area.
5. Make sure that there are diamond tools on the tool
plate and that they are tightly attached.
6. Connect the dust extractor to the product. Refer to
To connect a dust extractor on page 13 .
7. Adjust the handlebar to set the necessary work
height.
8. Connect the power plug of the product into the mains
outlet.
9. Make sure that you know in which direction the
motor rotates.
Make sure that the
Daily maintenance
11