Husqvarna BGS 250 Manuel D'utilisation page 10

• Do the operation in parallel tracks. Make sure that
the hose and the power cord (A) of the dust extractor
(B) and the product (C) do not become twisted.
B
A
C
• Make sure that the product always moves when it is
in operation.
• Sweep the product from side to side while you
operate forward.
Diamond tools
There are many types of diamond tools for the product.
Speak to your approved service center or go to to select
correct diamond tool.
To replace the diamond tools
WARNING:
power plug before you replace the diamond
tools, to prevent accidental start.
WARNING:
diamond tools can become very hot.
10
Always disconnect the
Use protective gloves, the
WARNING:
protection when you replace the diamond
tools. The dust below the grinding head is
dangerous to your health.
WARNING:
when you replace the diamond tools. The
dust extractor will decrease the dust that can
cause health problems.
1. Stop the product and disconnect the power plug.
To stop the product on page 12 .
Refer to
2. Adjust the handlebar to upright position.
3. Tilt the product rearward and fold down the
handlebar until the handle is on the floor.
CAUTION:
power cord and the dust extractor hose
do not become damaged when you tilt
the product.
Use approved respiratory
Use the dust extractor
Make sure that the
2363 - 003 - 22.05.2024