Husqvarna BGS 250 Manuel D'utilisation page 12

To start the product
1. Push down the handle lightly to lift the grinding
head from the surface, approximately 1 mm. This
decreases the pressure against the surface. Do not
lift the grinding head fully from the surface.
2. Push the ON button to start the product. In less than
5 seconds the product operates at the idle speed.
To stop the product
CAUTION:
the surface when you stop the motor. The
tool plate rotates for a while after the motor
stops. Much of the dust can blow off into the
air and the surface can become damaged.
12
Do not lift the tool plate from
1. Push the OFF button to stop the motor.
2. Keep the tool plate against the surface until it fully
stops. Make sure that the tool plate does not rotate
before you lift up the front.
CAUTION:
asphalt, paint or equivalent material, lift
up the front of the product slightly when
the tool plate stops. The product can
attach to the adhesive surface if it is not
lifted.
3. Pull out the power plug.
To change the position of the wheels
There are 2 possible wheel positions in the frame.
The rear hole (B) is used during standard grinding
and polishing operation. The front hole (A) is used to
decrease the grinding pressure.
B
A
1. Remove the bolts, the washers and the wheel from
the frame.
2. Install in the opposite sequence in the correct hole in
the frame.
If you grind adhesive
A B
A B
2363 - 003 - 22.05.2024