Husqvarna BGS 250 Manuel D'utilisation page 9

Introduction
WARNING:
product, you must read and understand the
safety chapter.
To adjust the handle and the handlebar
WARNING:
the handle and the handlebar. Make sure
that the handle and the handlebar locks into
position. The moving parts can cause injury.
Set the handle height as close as possible to the height
of the operators hip. During operation the product can
pull to the side. The hip of the operator can help to stop
this movement to the side.
1. Hold the handlebar and pull the handle adjustment
lever (A).
B
2. Adjust the handle (B) to an applicable operation
height.
3. Release the handle adjustment lever (A) to lock the
handle position.
2363 - 003 - 22.05.2024
Operation
Before you operate the
Be careful when you adjust
A
4. Loosen the handlebar adjustment lever (C) and
adjust the handlebar (D) to an applicable position.
D
5. Pull the handlebar adjustment lever (E) out and turn
it down to lock the handlebar into position (F).
E
F
Basic working techniques
• Make sure that the product always moves to get the
best grind result.
C
9