Publicité
Les langues disponibles
Les langues disponibles
General product maintenance
Clean the electrical enclosure.
Do a check of the electrical components, the cables and the
connections for wear and damages.
Do a check of the hose connections. Do a check of all hoses on
the product for damages or leakage.
Make sure that the dust hoses are not damaged and free of
blockage.
Make sure that the dust collector is empty and connected correct-
ly.
Do a check of the grinding disc for damages and wear. Refer to
To do a check of the grind holder on page 14 .
Do a check of the emergency stop button. Refer to
of the ON and OFF buttons on page 8 .
Do a check of the grinding head cover. Refer to
the grinding head cover on page 15 .
Make sure that the power cord and extension cable are in good
condition and not damaged.
Do a check of the residual curent device (RCD) for the power
suply.
Do a check of the rubber flexible coupling. Refer to
of the grind holder on page 14 .
Clean the product with a moist cloth.
To clean the product
CAUTION:
decreases the performance of the product
and can cause the motor to become too hot.
•
Always pull out the plug from the mains outlet before
you clean, do maintenance or assemble the product.
•
Always clean all the equipment at the end of the
work day. Do not use a high pressure washer to
clean the product.
•
Always do the maintenance on level ground.
•
Remove blockage from all air openings. The product
must always have sufficiently cool temperature.
To do a check of the electrical supply
WARNING:
cables. A damaged cable can cause serious
injury or death.
•
Make sure that the power cord and extension cable
are not damaged and in good condition.
•
Do not use the product if the power cord is
damaged. Let an approved service center repair the
product.
14
To do a check of
A blocked air intake
Do not use damaged
Daily
*
*
*
*
*
X
To do a check
X
X
*
*
To do a check
To do a check of the grind holder
WARNING:
power plug before you do a check of the
grind holder, to prevent accidental start.
WARNING:
diamond tools can become very hot.
WARNING:
protection when you do a check of the
grinder. The dust below the grinding head
is dangerous to your health.
CAUTION:
holder is important for the performance and
the safety.
1. Stop the product and disconnect the power plug.
To stop the product on page 12 .
Refer to
Each 3
Weekly
months
X
*
Always disconnect the
Use protective gloves, the
Use approved respiratory
The condition of the grind
2363 - 003 - 22.05.2024
Publicité
